Analysis: The proportion of "bearing" products in the hardware industry from January to June

The degree of concern is second only to the angular contact ball axis and the coaxial heat exchanger. It is a machine tool high-precision bearing and an imported bearing, accounting for 17% and 13% respectively. Imported bearings are limited to relatively domestic bearings.

In addition to coaxial heat exchangers, buyers are also more interested in angular contact ball axes, accounting for 26%. It can withstand both radial and axial loads. The greater the contact angle, the higher the axial load carrying capacity.


From the figure we can see that the coaxial heat exchanger became the most popular search term in June, accounting for 28% of the total bearing products. This product is mainly composed of concentric inner tube and outer tube. It has high safety and good processability and is not easy to leak. It is especially suitable for heat pump systems.

In the search of buyers, bearings, couplings and spherical bearings also accounted for a certain proportion, accounting for 7%, 5% and 4% respectively.

High Efficiency Spirotal Heat Exchanger

The equipment is made of two rolls forming spiral channels.Two kinds of heat transfer media can flow in full countercurrent, which greatly enhances the heat transfer effect, Even small temperature difference can achieve ideal heat transfer.
The nozzle of tangential structure with Low resistance, Due to helical channel are average curvature, There is no big liquid flow, Therefore, the design flow rate can be increased so it has high heat transfer capacity.
Type I Non detachableSpiral plateHeat exchanger`s helical channel are welded and sealed, so it has high sealing performance.
Type II detachableSpiral plateHeat exchanger`s Structure principle similar to above,But one of the channel can be disassembled and cleaned, especially for heat exchange with viscous and precipitated liquid.
Type III detachableSpiral plateHeat exchanger`s Structure principle similar to above,But two channels can be disassembled and cleaned,ranges aremore extensive.
The nominal pressure PN of spiral plate heat exchanger is 0.6, 1, 1.6 and 2.5MPa (refers to the maximum working pressure of single channel) , material can be divided into carbon steel and stainless steel.Customers can choose according to the actual process
When a single device cannot meet the requirements, multiple devices can be used in combination, but the combination must conform to the following provisions: parallel combination, series combination, equipment and channel spacing is the same. Hybrid combination: one channel in parallel, one channel in series

High Temperature Spiral Plate Heat Exchanger,Spirotal Heat Exchanger Equipment,Spiral Board Plate Heat Exchanger,Carbon Steel Spiral Plate Heat Exchanger

Yangzhou Tongyang Chemical Equipment Co., Ltd. , https://www.tongyangchemic.com